The color they chose is one of my favorites and I did a several projects using it.
One is the accent wall in my old bedroom. (The wall paper on the left is actually hand painted and you can see the tutorial here)
You can also find this shade on my IVAR ikea Hack:
But let’s talk today about my favorite chevron accent wall.
This wall was part of the living room makeover I did with my talented photogrfer friend Noa Magger. I will write a bit more about the project some day in the future but trast me, it was very impressive and you can check out the story to see what we did.
Just check put the before and after:
This is not the first chevron wall I made, You can read about the previous on here, but I think noa’s wall is far more elegant.
So lets get started:
Step 1: Prepare the room and the wall
You can see full instructions for this step in this post in case you are not sure what to do.
Step 2: Start marking a grid with a pencil
We are going to drew a grid on the wall, in order to make it easier to mark precise zig-zag lines. Use your ruler and level.
I decided to divide the wall horizontally in 5 so I could have 5 perfect “spikes”. On the vertical axis I decided to go about the same height as the doors and windows and I drew the strips gradually from wide on the bottom to narrow on the top.
Step 3: Mark the zig-zag layout with a pencil
Basically, you just need to link each intersection point to the other diagonally.
Step 4: Tape
After you drew your zig-zags you should start taping the painter’s tape. In this project, we are painting over the tape, so when we take it off we will get the white pattern of the unpainted stripes underneath. I used the thinnest tape I could find so I could get a very fine result.
Now, this step is tricky for two reasons.
1. You need to make sure you are using a masking tape that won’t tear off chunks of paint while peeling. And if you are not sure about it just use my “weakening” technique, by taping it to a piece of fabric first, and only then taping it to the wall.
2. You have to be very careful about the exact location of the tape sone the tape. I made sure I’m taping right underneath the pencil line.
Step 5: Paint
Paint the wall according to the paint manufacturer’s instructions. When you paint over the tape, try to squeeze the tape gently with your finger along the edges just before applying the paint, to avoid the paint from sneaking under the tape.
Step 6: Peel
As you probably know by now, this is my favorite part.
As soon as the paint is dry to touch, start peeling gently and slowly.
If you wait for too long, the paint will harden over the tape and will be pulled out of the wall when peeling.
Step 7: Finishes and touch-ups
After the tape is removed, Apply corrections to any smears using a little brush.
Use the base paint (in our case – white) and the new paint where needed.
Step 8: Enjoy your fabulous wall, and leave me a comment to tell me about your project!
Don’t forget to follow me on Instagram, and feel free to leave a note!