Step 1: Have the room ready for a mess!
Before painting, I recommend minimizing the chance of permanent damage from paint splashes.
First, move away the furniture, and cover them with plastic drop cloths.
Next, Give the room a thorough cleaning. Vacuum or mop floors, remove cobwebs and dust, and wipe down everything with a damp cloth.
Remove cover plates from switches and outlets – after shutting off the circuit breakers to the room (safety first!). Protect switches with tape and tape the screws to the back of the plates so you don’t lose them.
Cover doors, doorposts and trims with painter’s tape (also called masking tape). Cover the floor as well.
Step 2: Prepare the wall
Pull out any unnecessary nails or screws.
Fill in all the nail holes, dents, cracks and other forms of damage with a quick drying spackling paste. Allow it to dry according to the manufacturer’s instructions.
Sand out the areas you treated, apply a second coat and sand if necessary.
Sometimes you should prime the paint if it is lime painted, but if your walls are already covered in a low gloss, water-based paint, you can simply paint over the old paint.
Step 3: Start taping!
I used two types of tape with different thickness, and taped them quasi-randomly, while aiming for harmony in the layout.
I didn’t have a proper painters tape. Instead, I used a different type that required weakening because it could pull out parts of the base paint.
I achieved this by taping it to a piece of fabric first, and only then taping it to the wall.
It is a bit complicated with the longer strips, but skipping this step may result in damage to the paint. Don’t forget to contour the wall with the tape as well to avoid painting the ceiling and the adjacent walls.
You can see how I used painter’s tapes with different widths.
Step 4: Paint!!!
The following step is the second most fun past of the project. Paint the wall according to the paint manufacturer’s instructions. When you paint over the tape, try to squeeze the tape gently with your finger along the edges, to avoid the paint from sneaking under the tape.
Step 5: Peel..
Now, this is the most fun part!
As soon as the paint is dry to touch, start peeling gently and slowly.
If you wait for too long, the paint will harden over the tape and will be pulled out of the wall when peeling.
Step 6: Finishes and touch-ups
After the tape is removed, Apply corrections to any smears using a little brush.
Use the base paint (in our case – white) and the new paint where needed.
Step 7: Enjoy, and leave me a comment to tell me about your project!
See you soon with my next project.
P.S. You asked me where to get the wooden lamp.
I got it from Aliexpress:
Vintage Edison Wood Wooden Pendant Lights